How to install led corn bulb manufacturers

led corn bulb manufacturers https://www.zliec.com/LED-Ecolume-Corn-Lamp

In order to highlight the visual effect more, in some space decoration, often consider the installation of light strips, to increase the indoor atmosphere. How to install the light strip? Usually we have not been exposed to this part of the knowledge, and then through the following content introduction, let's have a look!

If there is a sticker on the back of the led corn bulb manufacturer, tear it open, paste it and secure it to the required installation position. If there is no sticker, secure it with an adhesive strip. Then, led corn bulb manufacturers are divided into three groups and connected in series into a circuit. Then, all the input power sources of led corn bulb manufacturers are connected together and unified to the main switch.

If you want to change the color of the light bar, you often need to install a controller, which can be eliminated by a single color light bar. But the distance of different controllers is not the same, like a simple controller is up to 15 meters, and the maximum distance of the remote control class is 30 meters. If the strip is very long, a power amplifier is often used.

If the light strip is installed outdoors, it will often be affected by other factors, resulting in use problems. If the use of sticker light strips, long time after use, the bonding effect will become low, so it is also necessary to install the card slot to fix, and then waterproof treatment.

The lamp strip is often coiled wire packaging, unwrapped unavoidable distortion, so we need to smooth it out before installation, and then placed in a fixed position. In addition, once the light strip is not smooth, it will often cause different lighting and shading effects. If it is installed around the ceiling, the overall effect will often be greatly reduced.

But the packaging of the lamp strip has not been opened, often can not be energized, because it will produce a large magnetic field, easy to appear security risks. In addition, if you need to cut the light strip, it must be cut in the marked place, not easy to cause a unit short circuit not bright. At the same time, when we are in series circuit, we must choose the same specification, current strip, and the length should be within the specified range. And in series connection, the lamp strip should be cut clean, and then connected with a male needle.

led corn bulb manufacturers https://www.zliec.com/LED-Ecolume-Corn-Lamp


tangram

38 Blog posts

Comments